![autodesk inventor assemblies autodesk inventor assemblies](https://i0.wp.com/thecadgeek.com/wp-content/uploads/2018/03/AutoCAD-2019-User-Interface.jpg)
To attain even better performance and fault tolerance, consider the use of a hardware RAID solution. (Combine two disks into a striped volume and put your Data files on it.) Do the same for Temp.
#AUTODESK INVENTOR ASSEMBLIES SOFTWARE#
If you have multiple disks available, you can use software RAID (Redundant Array of Inexpensive Disks), striped volumes, to increase the performance. Consider that the biggest performance gain is obtained in improving the speed with which Data and Temp are accessed.Ensure the OS\Applications & Data\Temp reside on different physical disks, at the least different partitions.Therefore, when more segments from the file are required, it is beneficial if they can be read as fast as possible.įollow these suggestions to improve performance: Inventor uses segment loading when accessing files, which means that only the required parts of the file are loaded in memory. Then it does not fragment, and there is no need to delete and recreate it. Create the page file first on the empty partition.
![autodesk inventor assemblies autodesk inventor assemblies](https://i.ytimg.com/vi/C-GzsZDliH0/maxresdefault.jpg)
Also, as the page file is already set to the maximum size, no time is wasted expanding it. The page file does not fragment or cause fragmentation of other files. Set the minimum page file size to the same value as the maximum page file size to increase performance when paging to disk. To eliminate fragmentation easily, delete all files in the system Temp folder after closing all applications. Putting the Temp files on a separate partition ensures that they do not cause fragmentation of other files. Separating the OS and applications is cosmetic, and does not result in much difference in performance. As files are heavily used, they fragment faster. So, the greatest benefit comes from increasing the read and write access speed to Data and Temp by using faster hard drives. Files located in Data and Temp are read and written often while you work with Inventor. There are a couple of reasons to separate these files:įiles located in OS and Applications are accessed frequently (when a program is started the files are loaded once into memory).